Infinity Hearts Wool Winder for Yarn Red/White 20x9.5x20cm

If you have any yarn in need of winding, you need a wool winder. This way you can turn thread into a yarn skein, which you can knit with more easily. A wool winder does this faster than you can do it by hand. They have the added advantage that you can pull the yarn off from both the middle and the outside of the yarn skein, depending on your preference.

When assembled, the wool winder is 12 cm long, 9 cm wide and 19 cm high. It is made of plastic, which is sand-coloured and red. The handle itself is made of metal and has a red plastic handle. The yarn arm with the eye is also made of metal, as is the clamp that holds the yarn winder.

The winder is easy to assemble and use. The handle is easy to clamp to your work surface using the red knob, which is an advantage for people with arthritis. Be careful not to tighten the clamp too tightly on the table edge. The yarn winder can be clamped on table edges up to 4 cm thick. You get a cross wrench that is easy to use and at a fair price.

Quick and easy installation of the wool winder

The package includes the wool winder itself, the spindle around which the yarn is wound and instructions in English. The spindle is attached to the rotating shaft by pressing it down onto the shaft and turning the spindle itself clockwise until it is firmly seated. Next, the wool winder is mounted on a table with the clamp, which is screwed on with the red button. Attach the device to the table by pushing it against the table with the clamp under the edge of the table. Tighten the clamp to the table by turning the red knob from left to right, i.e. clockwise. If you wish to remove the device, turn the knob anti-clockwise until the appliance detaches from the edge of the table. Then you just have to pull out the yarn eye from the appliance itself and turn it up into position. Be aware that the yarn eye must be pulled out about 3.5 cm and that it may be tight to fasten. Now you are ready to wind yarn on the wool winder.

How to use the Infinity Hearts wool winder

You get out your yarn and take one end of the yarn. Now wrap it around the yarn eye on the metal rod. Next, you attach the yarn to the top of the spindle itself, i.e. through the two small slots so that the yarn is held on the spindle itself. Now wrap the yarn clockwise around the spindle. Hold the yarn from the yarn eye a little tightly, while with the other hand you now turn the handle clockwise on the crossing device itself.

Featured patterns

Tilbehøre til håndarbejde